Prevention Of Accidents - Pfaff 034554030 Betriebsanleitung

Electric Stacker with Electric Travel
English
EGV ESL EPH
1. General
Before taking into operation, please carefully read this operating instructions.
Observe the safety instruction!
File documentation!
1.1. Introduction
With this manual we present to you your new Electric Stacker with electric travel.
Prior to initial operation, we recommend you to carefully study the following Operating and
Maintenance instructions and to consider our suggestions. This will help you to save time and
costs. Appropriate handling will also guarantee permanent serviceability and long working life.
The name plate fixed to the stacker giving type and Prüf-Nr. (serial number) is required for exact identification
of the stacker. Therefore, you are requested to advise the Prüf-Nr., type number and year of manufacture in
case of questions or spare part orders.
This Operating- and Maintenance Instruction should be accessible to all persons involved with the
operation, maintenance and service of the Electric Stacker with electric travel and should be re-
garded during their activities.
1.2. Trial and Practice Runs
Before using the electric stacker, we recommend you to make trial and practice runs. By practising, you will
learn sensitive handling of the stacker.
1.3. Readiness for Duty - Spare Parts
In order to avoid failure, even small damages should be repaired immediately by a competent person.
Only use original spare parts as per the enclosed spare parts list, otherwise safe function is not guaranteed.
2.

Prevention of Accidents

2.1. Destined use
The Electric Stacker with electric travel EGV ESL, EPH is intended for on-site transporting of unit loads, e.g.
in warehouses associated with industry and delivery companies etc., for short range transporting of standard
and wire mesh pallets, box pallets and other palletised loads on even and fixed surface.
The electric stacker with electric travel is a floor conveyor with power actuated travelling and lifting actuation.
It is a travelling floor conveyor with the short name EGV.
The electric stacker with electric travel is a wheel arm stacker with forks situated above the fixed roller arm.
This enables to move under pallets without support situated crosswise to the drive direction (wheel opening) .
2.2. Regulations for the Prevention of Accidents
The Electric Stacker with electric travel must be operated and used according to the current rules and regu-
lations.
Observe any rules which are valid for the respective country.
presently valid in Germany:
German UVV safety standard BGV D 27
EC Directive EN 1157-1; DIN-EN 1757-1
EN 50081-1; EN 50082-2; EN 61000-4-2
EC Directive 98/37/EG
VDI - Regulations for floor conveyors (obtainable through Beuth Verlag - Berlin - Köln)
It is absolutely essential that the operating instructions below and the BGV D27 regulations for pre-
vention of accidents are carefully read through before starting use.
Design changes under reserve!
F8.1.20
page 20
!