Installation Guide; Installation Steps - Danfoss RET2001OT - V2 Bedienungsanleitung

Installation Guide

1 . Installation Steps

EN
User Guide can be downloaded from: heating.danfoss.com.
1 . Installation must be done by an authorised
electrician .
2 . The room thermostat should be installed at approx .
1 .5 m above floor and where the effects of sunlight,
draught or other heat sources (eg . TV's) are avoided,
see fig . 1 on page 44 .
3 . First loosen lower retaining screw and carefully
remove back plate, see fig . 2 on page 44 .
4 . Mount back plate direct to wall or on wall box and
wire according to application, see fig 3 on page 44 &
wiring diagram on the next page .
5 . Locate hooks at top of front part into top of back
plate and lower into position and tighten retaining
screw .
4
RET2001OT - V2
AN30483479654801-010102 Danfoss Climate Solutions