STIEBEL ELTRON WSH 10 Bedienung Und Installation Seite 21

INSTALLATIoN
Preparation
9. Preparation
9.1 Installation location
Installation example:
10. Installation
Material losses
!
Refer to the operating and installation instructions for the
DHW appliance. Only use aerators that are permissible
for the DHW appliance.
Note
During installation, ensure that the connection hoses are
not kinked, turned or interchanged and that the electrical
connection is not damaged.
www.stiebel-eltron.com
f Install the strainer and gaskets (the tee is not included in the
standard delivery). Strainers are self-sealing.
Only WSH 10:
f Connect the sensor tap to the power supply unit. Connect up
the power supply unit.
11. Commissioning
f Flush the pipeline.
f Open the angle valve. Adjust the water to the required vol-
ume at the angle valve.
A
C
E
13
f Commission the sensor tap:
A Remove the label.
B Wave your hand within range of the sensor.
C Move your hand out of range of the sensor.
D Water runs for approx. 4 seconds.
E Wait another 10 seconds. The sensor tap is now ready for
operation.
B
1x 2 Sec.
D
10 sec.
WSH 10 | WSH 20 |
4 sec.
21