STIEBEL ELTRON WSH 10 Bedienung Und Installation Seite 19

opERATIoN
Troubleshooting
4.4.3 Hygiene flush 12/24/48 hours
You can set a hygiene flush to take place 12, 24 or 48 hours after
last use.
The hygiene flush time corresponds to the setting for continuous
draw-off (see chapter "Extended settings / Continuous draw-off /
Setting continuous draw-off in minutes").
Factory setting: OFF
Setting/activating the hygiene flush start time
Note
f Make sure that the drain is always clear to prevent
overflow due to the hygiene flush.
2 s 1x
25 s 1-4x
1x
... s
Setting the hygiene flush time
See chapter "Extended settings / Continuous draw-off / Setting
continuous draw-off in minutes".
Deactivating the hygiene flush
1x
www.stiebel-eltron.com
f Touch the touch area for
2 seconds. The orange LED
lights up.
f Touch the touch area for ap-
prox. 25 seconds (ignore the
red LED after 5 seconds and
orange LED after 10 seconds).
The red LED flashes one to
four times. The number of
flashes determines the hy-
giene flush start time:
1x red LED = OFF
2x red LED = ON after 12 h
3x red LED = ON after 24 h
4x red LED = ON after 48 h
f Move your finger away from
the touch area when the num-
ber of flashes corresponds
to the required setting. The
orange LED flashes once to
confirm.
f The hygiene flush is carried
out automatically after the
last draw-off (according to the
programmed start time).
f Touch the touch area briefly.
5. Troubleshooting
Observe chapter "Recalibrating the sensor" to restore the factory
settings.
Problem Cause
Water does not run. The sensor does not rec-
ognise black objects.
The sensor is flashing. The sensor is dirty.
Reflection in the wash-
basin.
Short spray of water at The power supply is in-
the tap outlet. sufficient.
The sensor is dirty.
The tap switches inde- Reflections in the wash-
pendently. basin trigger the flow of
water.
The water flow is too low. The aerator is blocked.
The tap switches off. An object is within range
of the sensor for approx.
90 seconds without
moving.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate on the cold water supply (000000-
0000).
5.1 Recalibrating the sensor
Your settings will remain unchanged after recalibration. The sen-
sor is automatically recalibrated to the washbasin.
2 s 1x
2x
2x/1x/...
5 s
4x
1x 1x
Remedy
Select an object with a
different colour.
Clean the sensor (see
chapter "Cleaning and
care").
Remove the object or
carry out recalibration.
Restore the power supply
or replace the battery.
Clean the sensor.
Recalibrate the sensor.
Clean/replace the aer-
ator.
The tap automatically re-
calibrates the sensor.
f Touch the touch area for 2 sec-
onds. The orange LED lights
up once.
f Touch the touch area brief-
ly twice (0.5 seconds). The
orange LED gives two short
flashes and one long flash.
The red LED pulses.
f Touch the touch area for ap-
prox. 5 seconds until the LED
has flashed red four times. Do
not reach into the sensor area.
f The water will run briefly
and the orange LED lights up
once. The tap is then ready for
operation.
WSH 10 | WSH 20 | 19