STIEBEL ELTRON WSH 10 Bedienung Und Installation Seite 18

opERATIoN
Settings
Deactivating the draw-off pause
The pause is ended automatically after 2 minutes or by touching
the touch area for 2 seconds.
2 s 1x
4.4.2 Continuous draw-off
You can set continuous draw-off for 0.5 to 20 minutes to fill the
washbasin or containers, etc.
Activating continuous draw-off
Factory setting: approx. 2 minutes
1x
2 s
3 s
Deactivating continuous draw-off
1x
18 | WSH 10 | WSH 20
f Touch the touch area for 2 sec-
onds. The orange LED lights
up once to confirm.
f Touch the touch area for 2 sec-
onds. The orange LED lights
up once.
f Touch the touch area for
3 seconds. The water will run
for approx. 2 minutes (factory
setting or another preselected
time).
f Touch the touch area briefly.
Setting continuous draw-off in minutes
Set continuous draw-off from 0.5 to 20 minutes (in increments of
0.5 minutes).
Factory setting: approx. 2 minutes
2 s 1x
1x
3 s
1-40x
...x/1x
f Touch the touch area for 2 sec-
onds. The orange LED lights
up once.
f Touch the touch area for 3 sec-
onds. The orange LED flashes
once (move your finger away
from the touch area before the
red LED flashes). The water
will run when you move your
finger away from the touch
area.
f Touch the touch area until the
red LED flashes. The number
of flashes corresponds to the
relevant increment:
1x red LED = 0.5 min
2x red LED = 1 min
3x red LED = 1.5 min
...
40x red LED = 20 min
f Move your finger away from
the touch area when the num-
ber of flashes corresponds
to the required setting. The
setting is confirmed by the ap-
propriate number of flashes.
The water will run. The or-
ange LED then lights up once
to confirm.
www.stiebel-eltron.com