Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Use with Non-SainSmart CNC machines
Please refer to the manual of your CNC router for assembly instructions. Pay attention to the required cable
lengths and the pin-out of the supply lines to the Laser Head and the Laser Control Module.
Due to its various options (2-pin PWM, 3-pin PWM including power, separate DC power jack) this laser module
kit is suitable not only for the SainSmart 3018-PROVer but also for a variety of other CNC routers.
However SainSmart can not guarantee proper function with all 3
Power
The Laser control module requires 12VDC capable of supplying 3A. This can be provided either from the
Router Main board using the 12V connection on the 3 pin connection OR by the included external power
supply. Do not connect both at the same time or the boards could be damaged.
PWM-Signal
This laser uses a standard PWM (0 to +5V) signal for control. The Laser is on when the PWM Signal is +5V and
is off when the signal is 0V. The PWM signal and ground can be connected by either the 2 pin connector or the
3 pin connector.
The provided cables may not be suitable for all connections, ensure that the correct pins on your router main
board are connected to the matching pins on the Laser Control Module.
16
rd
party CNC router control boards.
Werbung
