Connecting To A Sainsmart 3018-Prover - Genmitsu CNC 3018-PROVer Benutzerhandbuch

Connecting to a SainSmart 3018-PROVer

Connecting the Laser Control Module to
a SainSmart 3018-PROVer using the
2-pin cable for GND and PWM and the
supplied external power supply for the
Laser Control Module.
As shown the Laser control module is
mounted vertically with the power supply
socket at the bottom.
The two pin cable is connected to the
middle socket of the router Main Board
marked PWM.
When power is supplied via the external
power supply a Red LED near the FAN
connector will light on the Laser Control
Module board.
08