Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installing LaserGRBL to use with 3018-PROVer
The LaserGRBL window should now look like this. The three added buttons are arranged from left to right and
contain the following functions:
Tun on laser at low power (S100),
press again to turn off.
Set for Laser mode ($32=1)
Turn on the laser at low power
(S100) for 2 seconds, then turn it
off again (useful when setting an
origin position)
NOTE: The laser power is set by 'S100' in the
custom button commands but this is dependent
on the Maximum spindle speed ($30) set on the router If your maximum spindle speed has been changed you
may need to adjust the laser power by editing the buttons to change the S100 value. When the Laser is on the
power should be set so you can see the dot the laser beam makes while wearing the Laser Goggles, normally
the S value should be 10% of the $30 setting.
12
Werbung
