Waeco CoolMatic CR-65 Bedienungsanleitung Seite 42

_cr-kuehlschraenke.book Seite 42 Donnerstag, 5. Juni 2008 12:19 12
Installing and connecting the refrigerator
The appliance is designed for ambient temperatures between +18 °C and
+43 °C. In continuous operation, the air humidity may not exceed 90 %.
Set up the fridge in a dry, sheltered place. Avoid placing it near heat sources
such as radiators, gas ovens, hot water pipes etc. Do not let it stand in direct,
strong sunlight.
Install the refrigerator so that the warm air produced can easily flow away
(either upwards or to the sides). Therefore make sure there is adequate
ventilation (fig. 8, page 6).
No. in
fig. 8,
Explanation
page 6
1 Cold intake air
2 Hot waste air
3 Condenser
4 Spacing above the fridge if insufficient air can circulate
above or at the side.
The condensation which forms during normal operation of the refrigerator
can be drained off via two outlets on the appliance. For delivery purposes,
these outlets are sealed. The two outlets are located on the rear and on the
underside of the appliance (fig. m, page 12).
➤ Choose the condensation outlet most suitable for the place of installation
and remove its cap.
➤ Insert a sharp object (e.g. a screwdriver) approx. 25 to 30 mm into the
outlet to pierce open the inside of the appliance.
If you put the refrigerator in a recess, you can fix it inside with suitable screws:
➤ Remove the blanking plugs (fig. 7 2, page 6).
➤ Push the refrigerator into the recess.
➤ Use suitable screws (fig. 7 1, page 6) to fix the refrigerator in place.
➤ Press the blanking plugs (fig. 7 2, page 6) into the openings.
42
COOLMATIC CR Series