HEIDENHAIN MSE 1180 Installationsanleitung Seite 26

Connecting a network cable (MSE 1184)
MSE modules communicate with a PC through an RJ-45 connection 5 located on the
base module. Use a straight-through cable when connecting to a hub or a crossover cable
when connecting directly to a PC.
To connect a network cable:
Verify power is removed from all power supply modules in the module chain
X X
With the cable connector locking tab facing up, insert the cable connector into the
X X
RJ-45 connection 5 on the module until the tab locks into place
Connecting an encoder
This product can be used with HEIDENHAIN linear and rotary encoders that provide 1 V
signals. The connecting cable must not exceed 30 meters in length.
To connect an encoder:
Verify power is removed from all power supply modules in the module chain
X X
Connect the encoder cable connector to the encoder connection 6 on the module and
X X
Tighten the cable connector screws until they are snug
5
RJ-45 connector
6
PP
Encoder connector
26