NOESIS Florio F10 Pro Bedienungsanleitung Seite 29

Error Error Possible Cause Possible Cause
Failure To
Update User error
Firmware
ROBOT AND BASE STATION
Error Error Possible Cause Possible Cause
1. The bumper is stuck
Bumper Error
2. The bumper is dirty
Please Wipe The
The surface of cliff sensor is dirty
Cliff Sensor
Please inspect the
The carpet sensor is blocked by foreign objects
carpet sensor
Please clean the
The drive wheels of robot are stuck by foreign objects
drive wheels
Please clean the
The brush roll is entangled or stuck by foreign objects
brush roll
EN
Solution Solution
Firmware update prompt:
Errors may occur if firmware directions are not followed correctly.
1. Before the firmware update, ensure the base station is powered on and
the robot is in the base station fully charged.
2. During the firmware upgrade, please do not take the robot out of the
base station, do not try to operate the robot or base station buttons, and
do not try to use the robot.
3. Please keep the robot connected, make sure the Wi-Fi network is
normal, and click on the APP to start the firmware upgrade. The firmware
upgrade takes about 5-15 minutes.
4. The previous firmware version will be overwritten once the firmware is
successfully upgraded.
Please contact us if you have any questions.
Solution Solution
1. Inspect the bumper for any foreign objects. Ensure the bumper can
operate properly by being able to push it in and out
2. Wipe the bumper clean with a dry cloth
Wipe the cliff sensor and start it again after moving to a new position
Remove the foreign objects blocking the carpet sensor
Remove foreign objects stuck in the drive wheels
Remove foreign objects entangled or stuck in the brush roll
29