Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Note: To change from slow mode speed to normal speed without stopping, press and hold the
start button, release the footswitch and then release the start button.
Changing to normal speed will not deactivate slow mode.
Pressing the footswitch again will slow down rotation to slow mode speed again.
5.3 Placing film rolls
5.3.1 Auto-grip shafts
Both shafts in the front of the machine are the same. The shafts fit into the machine in both ways.
Their function is determined by their position in the machine and the setting of the tension control.
The shafts on the rear side can swing out of their support on the control panel side. On the other
side the shaft is fixed to the machine.On the control panel side of the machine all the shafts and the
supports snap together by a gripper slot and gripper. A spring inside the left-hand side support
pushes the shaft into locking position when the shaft is turned. To position the shaft correctly push it
firmly into the supports and turn the shaft until it locks in.Check the auto-grip mechanism on each
shaft. The rubber cords should just touch the edges of the recess (Figure 13A: d = 8 ± 2.5 mm).
If not, see chapter 6 Maintenance.
Figure 13: Auto-grip shaft
When the shaft is rotated inside a cylinder, the rubber cord will move to the side and gets caught
between shaft and cylinder (Figure 13B). Rotating back will release the cord.
5.3.2 Use of films with release liner
When using a film with a release liner that must be removed, load the wind-up shaft with a scrap
core (empty cardboard cylinder) of (at least) the same width as the film.
Take the auto-grip shaft from the wind-up position of the machine.
1.
Place the scrap core on the shaft, holding the shaft as in Figure 13C.
2.
CAUTION:
Do not drop the end of the shaft on the floor.
Put the shaft with cylinder back into the machine.
3.
Push both sides of the shaft firmly into their supports.
4.
Turn the shaft until the grippers lock in.
5.
Werbung
