SEAL 62 Pro S Betriebsanleitung Seite 18

4 INSTALLATION
WARNING:
INSTALLATION MUST BE CARRIED OUT BY SKILLED PERSONNEL.
Note: Make sure that the machine, in its final location, has adequate space. You will need room
to feed, receive and trim images.
4.1 Unpacking
At delivery, the machine is packed in a plastic bag to avoid moisture penetration. It is transported in
a carton box and is fastened onto a wooden pallet.
Note: Unpacking the machine requires at least 2 persons.
The machine is equipped with castors that allow easy movement.
Place the pallet in a space where there is enough room to roll the machine off from the pallet
(approx. 3x the length).
To unpack, follow the steps below (refer to Figure 7);
Cut the straps and lift off the carton box.
1.
Remove the plastic bag.
2.
Place the two ramps (4) against the roll-off side of the pallet so that the castors (5) will run clear
3.
from the edge.
Figure 6: Ramp positioning.
Put all the loose accessories aside.
4.