SEAL 62 Pro S Betriebsanleitung Seite 23

Sets the speed anywhere in a range between 0 and 10 (See specifications for actual speed range).
Reverse (12), snap pushbutton;
Press and hold for rotation of the rolls in reverse direction.
Reverse indicator (13), LED;
The LED will light when the reverse mode is selected.
5.1.2 Heater control
The heater-control above the control panel regulates the temperature of the upper main roller.
Figure 10: Heater-control section.
The heat is turned ON and OFF by the 0/I switch (1). Press I to turn the heat ON. The actual roll
temperature (4) is shown on the control display. The heat has a factory defined temperature range.
Within this range the roller temperature can be regulated. The temperature set point is displayed
when the SEL (5) button is pressed, and changed by pressing the up (6) or down (7) buttons.
Note: When the temperature set point is being displayed, the light by SV (3) is lit. Press the SEL
(5) button again to return to the actual temperature or the the display will return back
automatically in about 20 seconds.
If the actual temperature is lower than the set point temperature, the heat is turned ON and C1 (2)
is lit.
Note: The heated roller needs time to reach its set temperature (e.g. from room temperature to
maximum takes approximately 1 hour). It is recommended to let the machine run at a low speed,
to avoid uneven hot spots.
Operating
15