SEAL 62 Pro S Betriebsanleitung Seite 27

5.2 Operating modes
The machine is either in normal mode, or slow mode. In both normal and slow mode the rollers can
rotate in forward or in reverse direction.
5.2.1 Normal mode
When slow mode is not activated (normal mode), the rotation speed of the rollers is set via the
speed control knob.
Start rotation by pressing the forward button, the reverse button or the footswitch.
Rotation stops when a stop button is pressed or the footswitch is released.
Note: To return control from the footswitch to the control panel without stopping, press and hold
the forward button, release the footswitch and then release the forward button.
An interruption of the light beam of the optical safety device in front of the rollers will also stop the
rotation of the rollers. To continue after the interruption is taken away, the process must be started
again.
Reverse
WARNING:
KEEP CLEAR OF THE REAR SIDE NIP WHEN RUNNING IN REVERSE MODE.
When running in reverse, the optical safety device at the front side nip is ignored and the optical
safety device at the output side is active. The speed is determined by the speed control.
5.2.2 Slow mode
Enter or leave Slow mode by pressing the slow mode button for 1 second. The selection is
indicated by the slow mode indication LED. Entering slow mode will not change anything to the
current movement of the rollers.
In slow mode the rollers can run at normal or at slow mode speed.
Normal speed
Press the forward or reverse button in slow mode to run at a normal speed determined by the
speed control setting (see normal mode).
To start at slow mode speed or to switch from normal (forward) to slow mode speed just press and
hold the footswitch (when slow mode is selected).
Slow mode speed
Press and hold the footswitch in slow mode to force the rollers to run forward at a fixed low speed
(see specifications) independent from the speed control.
Slow mode speed is always running in forward direction. Slow mode speed in reverse direction is
not possible.
WARNING:
KEEP CLEAR OF THE NIP WHEN RUNNING AT SLOW MODE SPEED.
When running at slow mode speed, the optical safety devices are ignored.
When the footswitch is released, the forward rotation is stopped.
Operating
19