SEAL 62 Pro S Betriebsanleitung Seite 25

Unwind/wind-up tension control (5), knob;
By turning this knob clockwise an amount of friction is set between the shaft and the frame,
so this will act as a unwind brake.
Turning the knob counter-clockwise will release the brake.
Turning the knob further counter-clockwise will set an amount of friction between the shaft
and the driving sprocket wheel, so this will act as a coupling between motor and shaft. The
shaft will now act as a wind-up shaft.
Turning the knob clockwise will release the wind-up shaft again.
Wind-up tension control (6), knob;
By turning this knob clockwise an amount of friction is set between the shaft and the driving
sprocket wheel, so this will act as a coupling between motor and wind-up shaft.
To release the tension, turn the knob counter-clockwise.
In-feed table (7)
The standard in-feed table can swing up around the pivot point at the top of the table arms.
The image guide is attached to the input table and can be removed by shifting it from underneath its
retaining knobs.
Easy-feed table (option)
The Easy-feed table replaces the standard in-feed table when initially ordered from factory.
Figure 12: Easy-feed table controls
The Easy-feed table can swing up around pivot point (P) till it is upside down. In the upper position
it is stopped by the shaft supports and in the lower position by the table stops (M).
The in-feed table has a number of features to help feeding images correctly. Some of these
features can only be used in some of the processes.
The features and their controls (A to M) are described below.
Media trough (A)
To unwind a medium from a roll.
The trough can swing to the front (left) to be used or to the bottom rear (right) to be out of the way.
When the trough (A) is in position it is locked with a detent (B).
Media guide (C)
To help feeding in the medium straight the media guide can be set to one side of the medium.
Easy-feed rollers (G)
Another aid to feed-in the medium straight are the in-feed rollers.
Operating
17