Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Figure 8: Working space.
Turn down the four leveling feet until the castors are off the floor.
2.
Remove all transport material.
3.
•
Cut the straps around the shaft supports and remove the foam pads,
•
Cut the straps holding the in-feed table arms,
•
Cut the straps around the main roller axis and move up the top main roller to remove the
transport blocks from the nip,
•
Cut the straps holding the upper pull roller and open the pull rollers to remove the transport
plates.
Put a spirit level (horizontal) on the upper main roller and (vertical) against the front of both
4.
cabinets to level the machine by adjusting the four leveling feet.
CAUTION:
Check the mains values before connecting. See section 3.4 for power supply details
Connect the machine to the mains using the power cable supplied with the machine.
5.
CAUTION:
Only if absolutely necessary, use an extension cable of ample capacity. Unroll the
extension cable completely.
WARNING:
MAKE SURE THE POWER SUPPLY CABLE AND/OR THE EXTENSION CABLE IS
NOT BLOCKING YOUR WAY AROUND THE MACHINE.
4.3 Transport
The machine can be transported on a smooth surface on its castors.
CAUTION:
Turn the leveling feet up completely to prevent them from bending or breaking if
accidentally bumping into an obstacle.
On rough surfaces use a pallet truck or forklift.
When moving the machine over long distances, use the original pallet and packing material and
follow the unpacking procedure in the opposite way.
Werbung
