Boiling Water - Silvercrest SWKS 3100 I2 Bedienungsanleitung

Boiling water

RISK – ELECTRICAL SHOCK!
Never place the electrical base 4 close to water – this would be a
►
potentially fatal risk!
WARNING – RISK OF INJURY!
► Always use freshly drawn water. Do not consume any water that has already
stood in the kettle for longer than one hour. Do not reboil water that has cooled
down. Always pour old water away. Microbes could have formed in it!
NOTE
► Always ensure that the ON/OFF switch
the mains plug is unplugged and the appliance is standing on the base 4.
Otherwise the appliance could heat up unintentionally as soon as the
mains plug is plugged in again.
1) Lift the kettle off of the base when filling it!
2) Press the release button 1 and open the lid.
NOTE
► When filling it, hold the kettle upright. This is the only way to read the
markings on the scale 2 correctly.
3) Fill the jug at least as far as the MIN mark, so that the appliance does not
overheat, and no more than the MAX mark to ensure that no boiling water
can spill out.
4) First close the lid, then place the kettle on the base 4, so that it sits securely
on the base 4.
5) Now insert the plug into the mains power socket.
6) Push the ON/OFF switch
WARNING – RISK OF INJURY!
► For safety reasons you should not open the lid when the water is boiling or
extremely hot. There is a risk of scalding.
7) The light in the ON/OFF switch
8) As soon as the water is boiling, the appliance will switch off automatically, the
ON/OFF switch
■ 50 │ GB │ MT
3 downwards so that it engages.
3 shows that the appliance is now heating up.
3 clicks upwards and the light goes out.
3 is not pressed down when
SWKS 3100 I2