Zipper Maschinen ZI-MD500HST Betriebsanleitung Seite 36

2 Throttle control: Controls engine speed. Put the throttle control on low speed (L) or high speed (H).
3 Right steering lever: Operate the lever to turn right.
4 Clutch control lever: Squeeze the lever, clutch engaged. Release the lever, clutch disengaged.
5 Left steering lever: Operate the lever to turn left.
7 Gear selection lever: Controls forward (3x) or reverse (1x) movements of the machine.
8 Tipping handle: Controls the tipping of the dump box.
13.3 Start up
13.3.1 Fill in engine oil
ATTENTION! For transport motor oil has been drained. Fill up with 4-stroke quality motor
oil before first operation! Failure to do so will result in permanent motor damage and
void guarantee!
A too low oil level will cause damage to the engine and shorten the service life of the ma-
chine. Therefore, check the motor oil level before every start and if necessary fill up with
oil.
13.3.2 Refuel
Use only unleaded fuel with min. 95 octane (corresponding device fuel)
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
WAR N I N G
1. To check the engine oil level, place the machine on a flat,
level surface. Switch off the motor and wait for ten
minutes to allow the circulating oil to collect in the oil
pan.
2. Unscrew the oil-dipstick and wipe with a clean, lint-free
cloth or a non-fibrous paper towel.
3. Push the dipstick back into the opening as far as possible,
but do not screw it in. (Make sure that the dipstick is really
pushed in completely - occasionally it gets jammed).
4. Pull out the oil dipstick again and check the oil level.
There are two markings for this - see illustration on the
left.
5. If the oil level is low, fill up the recommended oil to the
upper rim at the maximum (maximum filling volume: see
technical data: do not overfill!)
6. Insert the oil dipstick again and retighten it.
7. Wipe away oil residues.
WAR N I N G
Never use 2-stroke mixture of diesel! DAMAGE OF ENGINE!
N O TE
OPERATION
36
ZI-MD500HST