Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX operation
To be able to operate the device in DMX mode, it must first be set to d512 under the Mode menu item (see
Menu structure).
Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 64 control channels.
However, it can also be switched to a mode with 3, 4, 11, 21-1 or 21-2 channels if different functions are
required. To be able to operate the device with a DMX controller, the DMX starting address must be set. The
starting address depends upon which DMX controller is being used. Please refer to the controller's
documentation.
1
Press the MENU button so many times until Chnd is indicated on the display. Confirm with the ENTER
button.
2
The display indicates 3 CH (3 DMX channel), 4 CH (4 DMX channels), 11 CH (11 DMX channels), 21-1
CH (21-1 DMX channels), 21-2 CH (21-2 DMX channels) or 64 CH (64 DMX channels). Use the buttons
UP and DOWN to select the desired DMX channel mode. Confirm with the ENTER button.
3
Now the display indicates the menu item for the DMX start address Addr. Use the buttons UP and
DOWN to set the address. Confirm with the ENTER button.
4
The display will not flash when DMX signals are being received. If no control signals are available, the
display will flash.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed to the
same address, they will work synchronously.
Segment- and LED arrangement:
Segment 1
LED 1
Functions in DMX mode
3-channel-mode
Channel
1
2
3
4-channel-mode
Channel
1
2
3
4
Segment 2
Value
Function
000 – 255
Red 0-100%
000 – 255
Green 0-100%
000 – 255
Blue 0-100%
Value
Function
000 – 255
Red 0-100%
000 – 255
Green 0-100%
000 – 255
Blue 0-100%
000 – 255
White 0-100%
Segment 3
31/36
Segment 4
LED 16
00147781, Version 1.0
Werbung
