Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Remote control IR-7
The IR remote control will only work in stand-alone mode, it will not work in DMX or slave mode Press the
buttons repeatedly to switch between the programs. The display indicates the current setting. When
actuating a button, always hold the remote control in the direction of the sensor at the control unit's front. A
direct line of sight between the remote control and the sensor is required.
Notes:
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
• If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.
Button
Function
BLACKOUT
LEDs off
AUTO
Automatic mode; program selection with (+)/(‒)
SOUND
Sound control; program selection with (+)/(‒)
Strobe effect for automatic mode and sound control;
SPEED
flash rate setting with (+)/(‒)
Running speed in
SENSITIVITY
setting with (+)/(‒)
Microphone sensitivity; setting with (+)/(‒)
DMX
DMX mode
Color mode; select colors with R/G/B/W;
MANUAL
setting with (+)/(‒)
FADE
Color fade mode
Color presets
0-9
Settings for 10 color presets *
* = See page 28
30/36
automatic mode and sound control;
00147781, Version 1.0
Werbung
