Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Preset colors
In the Colo mode the device will constantly emit one of 15 preset colors.
1
Press the MENU button so many times until Colo is indicated in the display. Confirm with the ENTER
button.
2
Use the buttons UP and DOWN to adjust the desired color (Co01-Co15). Confirm with the ENTER
button.
Display switch-off
This function LED offers you the possibility to switch the display on (ON) or off (OFF).
Display reverse
To invert the display by 180°, press the MENU button so many times until dISP is indicated in the display.
Confirm with the ENTER button. Select dSIP to return to the default setting.
Indicate software version
To indicate the version number of the firmware (operating system of the unit), press the button MENU so
many times until Ver is indicated in the display. Confirm with the ENTER button. The version will be indicated
in the display.
Reset to default settings
The device can be reset to default settings. Press the MENU button so many times until Rest is indicated in
the display. Confirm with the ENTER button.
Interconnecting several devices (master/slave operation)
To be able to operate the device in Master/Slave mode, it must first be set to Mast under the Mode menu
item (see Menu structure).
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1
To enter the total number of connected devices, including the master device, press the MENU button
repeatedly until the display shows MId. Confirm with the ENTER button. Now set the total number from
M1 to M14 (depending on the number of devices, maximum 14) with the UP and DOWN buttons.
Confirm with the ENTER button.
2
Then configure all slave devices before connecting them to the master device. To do this, press the
MENU button repeatedly until the display shows SId. Confirm with the ENTER button. Now set the slave
devices from "Id1" to "Id14" with the UP and DOWN buttons. Confirm with the ENTER button.
3
As an example for 10 devices: MId setting would be M10. SId settings would be Id1 to Id9.
4
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX
controller to the DMX input of the master unit.
5
Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronously.
29/36
00147781, Version 1.0
Werbung
