english
6.3.2
Mounting / Dismounting on DIN rail with or without pac-Bus
Mounting
Take care that the devices is not canted before it is snapped on the DIN rail.
Put the device on the DIN rail. Take care that the cut out of
the enclosure fits onto the edge of the DIN rail.
Swivel the device until it is snapped on the DIN rail.
Dismounting
Pull the latch (1) with the screw driver out.
Swivel the device out.
6.3.3
Mounting / Dismounting on pac-Carrier
Mounting
Dismount the black and the green terminal. (see chapter
8.3.3)
Single channel device: Dismount the cover of terminal slot 2.
(between black and green terminal)
Put the device on the pac-Carrier and swivel the device until
the red locking handle is locked.
Please check that the locking handle is locked.
Transmitter supply unit with limit values type 9162
Operating instructions
17