Stahl ISpac 9162 Serie Betriebsanleitung Seite 16

Operating Instructions
6 Arrangement and fitting
6.1 Dimension drawing
6.2 Installation
The transmitter supply units with limit values may be installed in Zone 2, Zone 22 or
outside hazardous areas. In the case of operation in Zone 2 or Zone 22, the transmitter
supply unit must be fitted in an enclosure which complies with the requirements of IEC/EN
60079-15 or IEC/EN 60079-31 (e.g. in an enclosure type 8146 from the R. STAHL).
6.3 Mounting and dismounting
6.3.1 Mounting of pac-Bus
The pac-Bus is an accessory, which facilitates the wiring of the power
supply and the common fault signalization.
The components of the pac-Bus type 9194 need to be ordered separately.
Assemble the required number of pac-Bus
elements.
Snap the pac-Bus segment on the DIN rail.
Assemble the terminal set at the beginning and
the end of the pac-Bus segment.
16
Transmitter supply unit with limit values type 9162
Screw terminals
Spring clamp terminals
english
Size X
108 mm
128 mm