CP 0006, CP 0006 SVR, CP 0066
Operation
WARNING
Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
►
Learn how the machine is switched off in the event
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.
Start and stop
A
CP 0006
A
CP 0006 SVR
CP 0066
Start the machine by squeezing the start and stop
♦
device (A) while firmly holding the handle.
B
CP 0006
9800 0611 90b | Original instructions
A
Safety and operating instructions
B
CP 0006 SVR
CP 0066
Stop the machine by releasing the start and stop
♦
device (B). The start and stop device returns
automatically to the stop position.
Operating
Starting a cut
Stand in a stable position, holding the scabbler
♦
with both your hands.
Press the scabbler slightly against the working
♦
surface, before you start.
Working
Let the machine do the work; do not press too
♦
hard.
Any form of idling or operating with an uplifted
♦
machine must be avoided.
When the machine is lifted, the start and stop
♦
device must not be activated.
♦
Check that the compressed air is clean, dry and
free from lubrication.
When taking a break
During all breaks you must place the machine in
♦
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
In the event of a longer break or when leaving the
♦
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.
B
13