Gas Connection; Connection Of Fume Exhaust Vent - Angelo Po 0S0FT4G Bedienungsanleitung

HANDLING AND INSTALLATION
WARNING: The connection opera-
tions must be carried out by qualifi ed per-
sonnel with an acknowledged experience in
the specifi c fi eld, in accordance with the ap-
plicable legislation in the country where the
appliance is installed.
The connection must be carried out with due
care and must comply with all applicable
regulatory and legal requirements.
When the connection is complete and be-
fore the appliance is put into operation, a
general check for any gas leaks is required.
To make the connection, connect the mains
line to the connection pipe of the appliance, fi t-
ting a shut-off tap (A) for the gas supply cut-off
when necessary.
WARNING: The tap (A), which is not
supplied with the appliance, should be in-
stalled in an easily accessible position and
its status (on or off ) must be identifi able at
a glance.
WARNING: The connection must be
made in compliance with the relevant appli-
cable legal requirements, and using appro-
priate and recommended materials.
Place the appliance under-
1)
neath the hood (A) (see fi g-
ure).
WARNING:
The gas supply to appliances
must be linked to forced-air
ventilation systems.
3378721_inst_GB

GAS CONNECTION

CONNECTION OF FUME EXHAUST VENT

A
A
IMPORTANT: The gas supply pipe
must comply with the national requirements
in force and must be periodically checked
and replaced if necessary.
HAZARD: Do not connect the appli-
ance to the gas distribution system contain-
ing carbon monoxide or other toxic compo-
nents.
WARNING: The gas feed pipe must
not be longer than 2 metres.
Connection to a fan extractor hood
To carry out this operation, proceed as follows.
A
ENGLISH
11