Attachment Of The Wall Holder; Loading Of Batteries; Fill The Chocolate Dispenser - Unold QUIRLY 8775 Bedienungsanleitung

Open the appliance and the chocolate dispenser

ATTACHMENT OF THE WALL HOLDER

1. For mounting of the wall holder, first mark the planned drilling holes with a
pencil. Make sure, that no electrical lines, water or drainage lines are in this
section. In case of a tiled surface, provide the holes in the joints.
2. Drill two small holes with a 5 mm drill.
3. Place the rawl plugs into the holes.
4. Fix the wall holder by means of the screws.

LOADING OF BATTERIES

1. The Quirly is operated by two alkaline batteries size AA.
2. Before installing the batteries make sure that the appliance is switched off.
3. To open the battery compartment cover, push the release button B at the
front side of the housing H with your thumb and remove the lid (see ill. I
and II).
4. Install the batteries according to the illustration F (+/-) inside the battery
compartment.
5. Replace cover into position by locking the tab D into position and pressing
the cover, until it snaps into its original position.
6. Briefly press the power button and observe operation of frothing spiral to
ensure that the batteries are functioning properly.

FILL THE CHOCOLATE DISPENSER

1. Fill the chocolate dispenser
2. Open the lid of the chocolate dispenser as shown on ill. I and II.
3. Fill chocolate powder into the dispenser.
4. Close the lid as shown on II. The lid must click into place.
14
Copyright UNOLD AG | www.unold.de