SUHNER ABRASIVE WH 15 Originalbetriebsanleitung Seite 22

seconds. Do not use vibrating grinding tools.
You must always hold the hand tool when it is operating.
Switch off the drive when you stop working.
The tool still needs time to stop after the tool has been
switched off.
Put down the hand tool so that there can be no danger.
Remove the hand tool from the shaft.
4. S
ERvICE
4.1 p
reVentiVe mAintenAnce
Always keep the hand tool clean and in a dry
place.
Worn mandrels must be replaced.
4.2 r
epAir
If despite strict observance of the manufacturing and test-
ing method the hand tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
4.3 w
ArrAnty
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages.
Complaints can only be honored if the hand tool is re-
turned in the undisassembled condition.
4.4 s
tOrAge
Temperature range during operation: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C.
4.5 d / e
ispOsAl nVirOnmentAl cOmpAtiBility
This hand tool consists of materials which can be dis-
posed of in a recycling process.
Before disposal, render the hand tool unusable.
Do not throw the hand tool into the garbage collec-
tion.
According to national regulations this hand tool
must be disposed of in an environmentally-compatible
recycling process.
22
/ m
aINTENaNCE