KEEWAY V-CRUISE Bedienungsanleitung Seite 54

[Replace]
1. Remove the big sprocket and small sprocket with tools;
2. Install the large pulley, small pulley, and transmission belt in the reverse order of disassembly and adjust the swing of
the chain;
3. Pay attention to the belt installation and debugging process: If the belt is operated incorrectly, the tension cord may be
broken.
This will cause the belt to lose tensile strength and tear, and there is a danger of failure!
●Avoid kinking, bending, twisting, knotting or turning over the belt, and never use it as a belt whip.
●Do not lift the belt with the sprocket during installation.
●Do not use (sharp-edged) tools to tamper with the belt.
●Do not oil or lubricate the belt.
●Do not try to open or repair the belt
CHAIN VERSION
Chain model: 428-132 [Check] (Picture 21)
1. Park the vehicle on a flat ground, switch to neutral, and turn
off the engine.
2. Swing the chain up and down, measure the swing amplitude,
the normal swing amplitude range:
10~20mm.
3. Check whether the chain locking clamp is loose and whether
the large and small sprocket are on the same level.
53