Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.
Press
to set timer or temperature.
Setting the timer
•
Using button
switch between temperature setting and timer setting.
•
Press
to enter the timer setting mode. The indicator
the timer using buttons (+) and (-) in the range 0-24h. Each time you press (+) / (-) you move the time by
1h. Press and hold (+) / (-) to change the values faster.
•
If the displayed value is different from 0, the countdown of the timer starts and once it reaches 0 the
appliance switches to standby mode.
•
If you do not press any button or if you press any other button than (+) / (-) within 5 seconds, the timer
setting stops and the display shows the room temperature.
•
When you finish the timer setting, press
Temperature settings
•
Using button
switch between temperature setting and timer setting.
•
Press
to enter the temperature setting mode so that the indicator
temperature using the buttons (+) and (-) in the range 15°~35°C. You change the temperature with each
pressing of (+) / (-) by 1 °C. Press and hold (+) / (-) to change the value faster.
•
Press
to exit the temperature setting mode, the appliance will hold the temperature you have set.
•
If you do not press any button or if you press any other button than (+) / (-) within 5 seconds, the timer
setting stops and the display shows the room temperature
•
The forst 10 seconds after you switch on the appliance, the temperature check is not performed. If the
ambient temperature is higher than the set temperature within 10 seconds from switching the appliance
on, the heater switches off, the indicator of high and low power mode turns off and the fan stops in 10
seconds. If the rotation function was active, the rotation stops as well. Other indicators and functions do
not change. Once the ambient temprature drops by 2 degrees under the set temperature, the heater starts
again, as well as the fan and rotation (if the roration function was active before).
Note:
If the timer and the temperature are set in the same time, the display will alternate every 30 seconds between
showing the temperature and the timer value. If the timer is not set, the display will show only the temperature.
Attention:
If you want to turn off the heater, always turn it off using both switches (on the control panel and the switch
0/I).
Overheating and rollover safety switch
•
The device will be switched off by internal thermal fuse in case of overheating.
•
Overheating could be caused by covering the ventilation openings on the rear of the appliance or by
covering the grill in front. When that happens, unplug the appliance from the outlet and let it cool for 30
minutes. Remove all obstacles and switch the appliance on again.
•
If the device stops working, the likeliest cause is a blown fuse. Please, contact an authorized service center.
•
The ceramic heater is equipped with a safety switch that in the event of overturning of the heater switches
it off automatically.
CLEANING AND MAINTENANCE
•
There are no parts inside the appliance that require your attention or maintenance. Do not attempt to
open the exterior covers of the appliance. This could damage the motor and the heater and void the
warranty. Have all service operations carried out by a qualified repair shop.
•
Before cleaning unplug the appliance from the outlet and let it cool thoroughly.
•
NEVER use water for cleaning the device and protect it from contact with water under all circumstances.
•
The outer cover can be cleaned using slightly damp cloth (if necessary use weak solution of mild detergent).
flashes on the display and you can now set
to go to the temperature setting.
turns on. You can change the
GB
27
27
27
Werbung
