Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING INSTRUCTIONS
When you first turn the ceramic heater on, you may detect a slight odour. This is not a malfunction. This is
common with most heaters, it is harmless and it disappears in a little while, after dust or grease residue, which
settled there after a longer period of inactivity or during the manufacturing process, burns off.
The properties of the
•
Ceramic heater, automatic regulation of power according to the ambient temperature.
•
Two power levels and the ECO function to save energy
•
Timer 1-24 hours
•
Automatic dimming of the display brightness
•
Option of automatic rotation for even distribution of heat.
•
Setting of ambient temperature function (15°C~35°C)
•
Safety switch in case of overturning, double protection against overheating (thermistor, thermal fuse)
•
Infrared light control
Preparing the appliance
GB
Put the body of the appliance in the base.
With regard to the above safety instructions plug the appliance into an appropriate electrical outlet.
Inserting battery in the remote control:
1.
Remove the cover of the battery compartment on the back of the remote control.
2.
Insert in the holder in the cover the battery CR 2032 (included), observe correct battery polarity.
3.
Insert the cover with the battery back in the remote control.
Appliance control
After plugging the appliance in the outlet, switch on first the I/O switch on the back in the position I. The
1.
appliance switches into stanby mode. When you hear a beep the indicator
and all the functions except for the power button are inactive.
2.
Press
button to switch the appliance on. Press again to switch the appliance off.
Attention: When it is off the appliance cools for another 10 seconds until it is entirely off. These 10 seconds
are counted down on the display. Before you turn off the heater using switch 0/I, always allow this process
to finish.
Initial state of the appliance after switching it on:
•
Power: Low heater power, the indicator of low power (
•
Rotating: Rotating is off, the rotation indicator
•
Timer: 0h (no time is set), the indicator
•
Temperature: Initial temperature is displayed. Indicator is on
•
Fan: On.
•
Setting temperature: Automatic default to 25°C.
3.
You can switch between the low and high power level during operation using the button
•
Low power level: Indicator
•
High power level: Indicators
You can switch on the power saving mode during operation by pressing the button ECO . The indicator
4.
turns on.
•
ECO mode: The default temperature is 22°C, when the temperature drops under 18°C the high power
level turns on, when the temperature increases over 18°C, the appliance switches to low power level.
When the temperature reaches 22°C, the heater turns off.
5.
Press
to turn on or off the rotation of the appliance. During rotation the indicator
the rotation is turned off the indicator is off.
26
26
26
appliance
is off.
is on, indicators
and
are on.
lights up. The display is off
) is on.
is off.
.
and
are off.
.
is on. When
Werbung
