Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Heki2 de Luxe
See fig. a
➤ Make sure the lights are fitted securely.
➤ Connect the power supply line to an available socket.
See fig. b
➤ Clip the ventilation grille (1) onto the long sides.
It needs to click in.
➤ Clip the light covers (2) onto the short sides.
They need to click in.
➤ Remove the protective film from both sides of the acrylic glass.
I
NOTE
If the protective film is exposed to sunlight for too long, it cannot be
taken off without leaving a residue.
➤ After installing, check the roof light works properly.
➤ If necessary, enter the new vehicle height and weight in the vehicle documents.
8
Using the Heki2 de Luxe
Opening in the tilting position (fig. c)
8.1
➤ Press the latches on both rotary bolts and turn them 90° (A).
➤ Hold the bracket in the middle and move it out of the original position (B).
➤ Tilt it downwards.
➤ Push the glass dome upwards (C).
Opening the glass dome is supported by the two gas springs after approx.
150 mm.
➤ Swivel the bracket to the glass dome and press it back into the original
position (D).
To close it, follow the instructions in the reverse order.
Opening in the half-way position (fig. d)
8.2
➤ Press the latches on both rotary bolts and turn them 90° (A).
EN
Using the Heki2 de Luxe
9
Werbung
