WARNING
With any action you take you should pay attention to the safety notes in
the corresponding paragraphs.
•
Charge process
•
Use with power supply unit
•
Mount the unit on a tripod (optional).
•
Adjust the inclination angle.
•
Connect the device to the electric power supply.
•
Switch the unit on / off - dimmer function
6. Charging batteries
•
Insert the round battery charger plug into the charger socket.
•
Only connect the device to an earthed socket.
•
The battery display LEDs will light up shortly after inserting 1 or 2 batteries
(depending on model) to show the current charge level.
•
If the batteries are not fully charged, the charger will automatically start to
charge after a short time.
• During charging, the LED diodes will flash, showing that charging is taking
place and the level of charge that has been reached.
•
As soon as the battery or batteries has/have been charged, the LEDs will re-
main lit. The charging process has ended and we recommend that you remove
the batteries.
NOTE
In order to ensure the longevity of the power pack you must charge the power
pack to full capacity before using the video light for the first time. Use the power
pack until it is completely discharged. Then recharge the power pack to full
capacity. Repeat these steps about 2 times.
30