Futurelight Stage Pixel Bar 10 WW Bedienungsanleitung Seite 26

Menu structure in Stand Alone Mode
Default highlighted in gray
Mode
ADDR: 001 ~ 512
CH:02
DMX
CHANNEL
CH:10
CH:12
SLAVE
SLAVE
SENS: 00 – 31, 25
SOUND
REP: 01 – 99, 03
SPEED: 01 – 99, 50
FLOW
5 programs
FLASH: 01 – 99, 00
SPEED: 01 – 99, 50
AUTO
REP: 01 – 99, 03
ON
PIXEL FLIP
OFF
MASTER
000 – 255
DIMMER
RESPON01
DIMMER
RESPON02
Password 000-255
FIXTURE ID
RDM ID 0000-9999
ETHERNET
SUBNET MASK
DMX UNIVERSE
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the DMX
output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller to
the DMX input of the master unit.
Press the MODE button to select the SLAVE MODE. The devices set in this manner can now be controlled
by the master unit.
Please press the ENTER button to confirm and the MODE button to exit the Mode.
Selecting an internal program
Press the MODE button to select the internal program mode FLOW. Select P01 – P05 via the UP or DOWN
buttons.
Press the ENTER button to select speed and flash settings, respectively. You can select the desired values
via the UP or DOWN buttons.
Speed from 01 to 99, increasing.
Flash from 01 to 99, increasing.
Please press the ENTER button to confirm and to exit the FLOW Mode.
Display Function
Setting DMX starting address
Setting DMX channel mode
Slave-setting
Microphone sensitivity
Frequency of the loops (chaser in an endless loop)
Speed of the programs
Strobe-Effect with increasing speed
Speed of the loops
Frequency of the loops (chaser in an endless loop)
Chaser direction: from right to left 10 - 1
Chaser direction: from left to right 1 - 10
Increasing brightness 0 – 100%
Dimmer speed 1 = LED
Dimmer speed 2 = Halogen
Passwort: 050
PROTOCOL
IP ADDRESS
ArtNet
XXX XXX XXX XXX
255.000.000.000
000-255
26/32 00114770.DOCX, Version 1.1