Klarstein BORNHOLM SMART Bedienungsanleitung Seite 25

2. Attach 2 brackets to the bottom of the unit (see picture below).
3. Hold the unit by the sides, pay attention to the position of the holes on the
back of the unit and place the unit on the wall brackets. This completes the
wall installation (see picture below).
Note: To avoid damage, make sure that there are no cables or pipes in the wall
before drilling. Make sure that the screws are tight and secure in the wall to
ensure a safe wall installation of the heater. Please observe the safety distance
given below.
• During installation, the heater must be located at a sufficient distance from
combustible materials and gas and away from water.
• For wall-mounted heaters, the mounting height above the floor must be more
than 15 cm and the distance to the ceiling must not be less than 50 cm.
EN
25