ABC Design Condor 4 Bedienungsanleitung Seite 12

8. Adjusting the leg rest
To adjust the leg rest, press in the buttons on both sides and then adjust the height.
Let go of the buttons again so that the leg rest clicks into place.
9. Fastening the harness
a.
To fasten the harness, bring the top two plastic catches together and interlock them.
b.
Then insert the interlocked catches into the bottom part of the fastening.
Adjust the harness to a setting where the baby is held in the correct
10. Unfastening the harness
To open the harness, press the button on the side.
CAUTION: Always use the shoulder harness and lap belt together.
11. Adjusting the seat unit
To adjust the seat unit, press and hold down the catches on both sides of the seat unit and adjust the
height of the seat. When you have reached the required position, let go of the catches to allow the seat to
remain in that position.
Carrycot
12. Opening the carrycot
Extend and secure the side panels by pulling the two loops outwards until the bracket engages in the
mountings.
Make sure that the retainers are securely engaged.
13. Fitting the adapter to the carrycot
Secure the adapter to the frame. Make sure that it locks into place properly.
14. Inserting the mattress
Insert the mattress in the cover.
Lay the mattress on the base.
NB: The mattress is wedge-shaped. Make sure that the raised part is at the head end.
15. Adjusting the handle
To adjust the handle, press the buttons on both sides.
Now you can adjust the handle.
To open out the sun canopy, undo the zip on the back section of the hood and pull the hood forwards.
WARNING: The carrycot must not be lifted by the handle when the handle is
in the furthest forward position. The handle may only be used in the vertical
position.
EN - 07