ABC Design Condor 4 Bedienungsanleitung Seite 11

Customer complaints
• No claims may be made for natural wear and tear or for damage caused by undue demands on the
product or by exceeding the permissible load.
• No claims may be made for damage caused by improper use.
• No claims may be made for damage caused by incorrect assembly or operation.
• No claims may be made for damage caused by improper modifications to the product.
• Areas of rust may appear through lack of maintenance or improper care and do not constitute a fault with
the product.
• Scratch marks are normal signs of wear and do not constitute a fault with the product.
• Mildew is likely to appear on textiles which are not dried out after getting wet and cannot be attributed to
shortcomings in production conditions.
• The product may fade if exposed to sunlight, perspiration and detergents, or if subject to abrasion or
excessive washing, therefore fading cannot be attributed to a fault with the product.
• No claims may be made for wheels which become worn out as a natural result of wear and tear.
1. Opening the pushchair
a.
Release the transportation lock.
b.
Pull the handle on the stroller (1) upwards until the frame clicks into place (2).
WARNING: Ensure that all the catches are engaged before use.
2. Fitting the wheels
a.
Fit the rear wheels in the slots until they engage firmly.
b.
To remove the wheels, press the button on the rear axle down to release the wheel.
The wheel can then be removed from the axle.
c.
To mount the front wheels, push the wheels into the fittings until they click into place.
d.
To remove the front wheels, press the buttons on the wheel fittings and pull the wheels out.
3. Wheel locking and swivel settings
Push the lever down to lock the wheels.
Push the lever downwards to set the wheels in swivel position.
4. Operating the brake
Press the lever down to engage the brake.
Press the lever up to disengage the brake.
5. Attaching and converting the seat
a.
Attach the seat by placing it on the frame until it clicks into place.
b.
To remove and convert the seat, pull the levers on both seat unit adapters and lift up the seat.
6. Attaching and removing the hood
Lower the hood down onto the attachment.
To remove the hood, press the buttons in on both sides of the hood.
To open out the sun canopy, undo the zip on the back section of the hood and pull the hood forwards.
7. Fitting and removing the guard rail
a.
Fit the guard rail by inserting it in the plastic mounts on both sides.
b.
To remove the guard rail from the pushchair, press in the buttons on both sides and pull the guard rail
off away from the pushchair
EN - 06