ABC Design Condor 4 Bedienungsanleitung Seite 13

16. Fitting the apron
Fit the closed end of the apron over the lower end of the carrycot.
Extend the apron over the cot.
Fasten the press stud on the hood to the press stud on the cot.
Now fasten the press stud on the apron to the press stud on the hood.
17. Mounting the carrycot on the pushchair
The adapter is fitted to the long side of the carrycot.
Place the carrycot onto the pushchair so that the catch mechanism engages.
To remove the carrycot, press the buttons on the adapter on both sides of the cot and lift the cot up to
release it from the catches.
CAUTION: Always check before use that the carrycot is correctly secured
to the pushchair.
18. Adjusting the handle
Push the button upwards to adjust the height of the handle.
When the handle is at the required height, let go of the button again so that the handle will remain locked
in this position.
19. Folding the pushchair
To fold the pushchair, bring the handle to its lowest position as described in point 19, holding the button
(1) down as you do so.
Now rotate the knob (2) to the left and push the handle down.
Now you can fold up the pushchair.
Note: To unfold the pushchair, follow the instructions in point 1 "Opening the pushchair".
20. Universal holder
a. The fittings for the Universal cupholder are located at the points indicated in the picture.
b. The universal fitting can hold ABC Design accessories, such as the ABC Design cupholder, changing bag
and parasol.
CAUTION: Ensure that all the catches are engaged before use.
EN - 08