Teka VTCT2DCE Einbauanleitung Seite 26

Installation
INSTALLATION AND SETUP SHOULD
BE CARRIED OUT BY AN AUTHORISED
TECHNICIAN IN LINE WITH CURRENT
INSTALLATION STANDARDS.
Positioning the hobs
GB
Depending on the model to be installed, an
opening with the dimensions shown in
figure 1 will be cut into the unit's worktop.
The system for fixing the hob is intended
for use with kitchen units with a thickness
of 20, 30 and 40 mm.
The hobs described in this manual can
only be installed with Teka ovens models
E or ES.
The minimum distance between the surfa-
ce supporting the cooking pans and the
lower part of the kitchen unit or the hood
located above the hob should be 650 mm.
If the hood's installation instructions
recommend that the gap is greater than
this, you should follow this advice.
The unit where the hob and oven will be
located will be suitably fixed.
The glues used in manufacturing
the kitchen unit and in the adhesive on
the decorative laminate of the worktop
surface should be made to tolerate tem-
peratures of up to 100ºC.
TEKA assumes no responsibility
for any malfunction or damage caused
by faulty installation.
During installation, care must be
taken not to break the glass.
PLEASE REMEMBER THAT THE GUA-
26
Important
Minimum distances
to walls
Minimum ventilation
distances
OVEN
Fitting holes
RANTEE DOES NOT COVER THE
GLASS IF IT SUFFERS A VIOLENT
BLOW OR IF IT IS USED IMPROPERLY.
Positioning the oven
See the corresponding manual.
Fixing the hob
When the gap has been properly sized,
the sealing washer should be put on the
fig. 1