Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Place the shaft on the housing of the cooker hood.
•
Mark the mounting holes on the wall and pre-drill the marks.
•
Fix the lower shaft bracket to the wall with 2 dowels and screws (4 mm x 30
mm).
Dowel
Shaft bracket
•
Pull the top/inner shaft up and out to the desired height. Mark the
mounting holes for the upper shaft bracket on the wall and pre-drill at the
marked locations.
•
Fasten the upper shaft bracket with 2 dowels and 2 screws (ST4 x 30 mm) at
the drilled points on the wall.
•
Attach the upper/inner shaft part to the bracket with 2 screws (ST4 x 8 mm).
5
6
4 mm x 8 mm
screws
4 mm x 30 mm
screws
EN
31
Werbung
