Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.2.7
Mounting the toothed rack and battery pack
Attach the toothed rack and pinion to the shaft.
Fix the toothed rack in the holder and click it into place.
48
Insert the battery into WinMatic from below.
7
Start-up
7.1
Adapting the window actuator to the window used
Please read this entire section before starting to make settings.
Set-up mode is used to make parameter settings, which are determined by the
properties of the window:
• Mounting of WinMatic on the left or right
• Pulling force
• Maximum tilt range
The set-up process is executed in stages.
Press the "close" and "open" buttons simultaneously for longer than four seconds to
enter (or exit) set-up mode.
If a master remote control has not yet been taught-in, you will enter set-up mode
directly.
49
Werbung
Kapitel
Inhaltsverzeichnis
