Kenwood NEXEDGE NX-700 Bedienungsanleitung Seite 25

Selecting a Number from the List
1 Select your desired zone and telephone group ID.
2 Press the key programmed as Autodial.
• The last called unit appears on the display.
3 Press /
4 Press the PTT switch to start the call.
■ Receiving a Telephone Call
When a call is received, press and hold the PTT switch to speak, and release it
to receive.
• Only one person can speak at a time.
EMERGENCY CALLS
If your transceiver has been programmed with the Emergency function, you can
make emergency calls.
1 Press and hold the key programmed as Emergency.
• Ask your dealer for the length of time necessary to hold this key before the
transceiver enters Emergency mode.
• When the transceiver enters Emergency mode, it will change to the Emergency
channel and begin transmitting based on how it is set up by your dealer.
2 To exit Emergency mode, press and hold the Emergency key again.
• If the Emergency mode completes a preset number of cycles, Emergency mode will
automatically end and the transceiver will return to the zone and channel that was in
use before Emergency mode was entered.
Note:
◆ Your dealer can set the transceiver to emit a tone when transmitting in Emergency mode.
◆ Your dealer can set the transceiver to emit tones and received signals as normal, or mute the
speaker during Emergency operation.
SCRAMBLER
Press the key programmed as Scrambler/ Encryption, or access the Menu
{page 9}, to switch the transceiver to secure (encrypted) transmission.
• Pressing the microphone PTT switch after the Scrambler function has been turned ON
encrypts the transmitted signal.
to select your desired list number.
17