Kenwood NEXEDGE NX-700 Bedienungsanleitung Seite 24

DTMF (DUAL TONE MULTI FREQUENCY) CALLS
■ Making a DTMF Call
Note: DTMF calls can be made only in analog operation.
Manual Dialing (Microphone Keypad Only)
1 Press and hold the PTT switch.
2 Enter the desired digits using the microphone keypad.
• If you release the PTT switch, transmit mode will end even if the complete
number has not been sent.
• If the Keypad Auto PTT function has been enabled by your dealer, you do not
need to press the PTT switch to transmit; you can make the call simply by
pressing the microphone keys.
Store & Send
1 Press the key programmed as Autodial.
2 Enter up to 30 digits using the microphone keypad.
• Alternatively, you can enter digits by using
3 Press the PTT switch or
■ Autodial
Autodial allows you to quickly call DTMF numbers that have been programmed
onto your transceiver.
1 Press the key programmed as Autodial, or access the Menu {page 9}.
• The fi rst entry in the Autodial list appears on the display.
2 Press /
number directly (01 ~ 32) .
• The stored entry appears on the display.
3 Press the PTT switch to make the call.
■ Stun Code
This function is used when a transceiver is stolen or lost. When the transceiver
receives a call containing a stun code, the transceiver becomes disabled. The
stun code is cancelled when the transceiver receives a call with a revive code.
TRUNKING CALLS (ANALOG)
■ Making a Telephone Call
Manual Dialing
1 Select your desired zone and telephone group ID.
2 Press the PTT switch to start the call.
3 Enter your desired number using the microphone keys.
16
ADVANCED OPERATIONS
to make the call.
to select your desired Autodial list number, or enter the list
/
{page 11}.