Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• The electronics continuously monitor that the control
commands are carried out correctly.
2. Product table
Type
OMUS®30Compact
Electronic hybrid switch IEC, 3-pole, complete with busbar adapter,
control and load plugs (spring terminals) and fuse links 32A gG, 10 × 38
Electronic hybrid switch UL and IEC, 3-pole, complete with busbar
adapter, control and load plugs (spring terminals) and fuse links Class CC
30A time delay
OMUS®60Classic
Electronic hybrid switch IEC, 3-pole, complete with busbar adapter,
control and load plugs (spring terminals) and fuse links 32A gG, 10 × 38
Electronic hybrid switch UL and IEC, 3-pole, complete with busbar
adapter, control and load plugs (spring terminals) and fuse links Class CC
30A time delay
Spare components
25A electronic components (with fuse links 32A gG, 10 × 38)
20A electronic components (with fuse links Class CC30A time delay)
30Compact busbar adapter
60Classic busbar adapter
Plug 41A, 3-pole, spring terminals 0.2 – 6mm²
Plug 41A, 3-pole, screw terminals 0.2 – 6mm²
Control plug, 12-pole, spring terminals 0.2 – 1.5mm²
Fuse 32A, gG, 10 × 38
Fuse, Class CC, 30A, UL listed
24
• No powerful electrostatic charges may be transferred
to the OMUS® from the load side
Pack Size
Weight Kg/100
Part No.
1
45.2
36 152
1
45,2
36 157
1
45.8
36 153
1
45,8
36 158
1
35.7
36 154
1
35,7
36 159
1
7.2
36 155
1
7.8
36 156
1
1.5
36 916
1
1.5
36 918
1
0.8
36 917
10
0.6
31 198
10
0.8
31 252
3. Brief instructions
3.1 Installation
1. Refer to the safety instructions and area of use.
2. If necessary, adjust the adapter to 10mm busbars.
3. Install the complete device on the busbar system.
4. Connect the load.
5. Connect the control plug: 24VDC supply voltage,
earth connection of inputs and the required inputs,
signal outputs, terminal assignment in section 6.
6. If required, change the limits (parameter settings, see
page 32)
7. Connect 400VAC 3 phases to busbar system.
8. Off we go!
3.3 Dismantling, replacing devices
1. Enable the busbar system, obey safety instructions
2. Remove the control plug
3. Remove the load plug
3.4 Power output balance
Switch on process
Switch off process
Contact bridges
semi-conductor
(bypass)
1. Level of power loss at semi-conductor for short
time only
2. Low power loss at mechanical contact for a
longer period
Revision 0, stand 05.2016
English.
3.2 Meaning of the LED indicators
• Normal operation: The green LED for the set
parameters is continuously lit
• Warning: Indicated by yellow LED
• Error: Shut down + red LED
4. Remove the electronics from the
adapter
Contact transfers to
semi-conductor
25
Werbung
