Miele professional A 814 Gebrauchsanweisung Seite 28

en - Areas of application
A 812 and A 813
adapters
28
Installation
Remove a nozzle from the injector manifold of your upper basket or

mobile unit.
Screw the holder in at this position. Tighten the holder with the aid

of an open spanner (width across flats 9).
To increase capacity, you can combine the A 814 holder with the
A 812 or A 813 adapters. Both adapters each have 4 ports. The A 814
holder may be fitted to a maximum of 3 ports. The 4th port must al-
ways be sealed with a blind stopper.
– The A 812 adapter can be used on injector manifolds with silicone
adapters.
– The A 813 adapter is intended for use on injector manifolds with
screw connections.
Follow the fitting instructions in the operating instructions for the

A 812 and A 813 adapters.
Screw the A 814 holders into the ports on the adapters.

 Ports that are not in use must be sealed with a blind stopper.
The 4th port must always be sealed with a blind stopper.