Hilti PRA 300 Bedienungsanleitung Seite 20

en
6.3.3 System setup
The following items appear in the menu: "Activate / deactivate beam shields"
are available only when the PRA 300 and PRA 300‑HV2S are switched on and both devices have been paired with
each other.
6.3.3.1 Activating/deactivating the beam shields
The laser beam from the PR 300-HV2S can be shut off at one or more sides of the tool. This function is useful when
more than one laser tool is in use on a construction site and you wish to avoid detecting the beam from more than one
laser at a time. The laser plane is divided into four quadrants. These are marked on the casing of the tool and can be
set as follows:
1. In the menu
2. Select the "Activate / deactivate beam shields" function
3. Use the arrow keys
4. Activate / deactivate the desired quadrants by pressing the OK key
5.
Confirm this setting by pressing the OK key
If the quadrant is visible its status is "On". If the quadrant is not visible its status is "Off".
6. Press the "Back" key
normal operating mode.
NOTE Settings that affect the rotating laser only become effective when the rotating laser is switched on and a
wireless connection has been established.
6.3.3.2 Activating / deactivating sleep mode
The PR 300-HV2S saves power when in sleep mode. The laser is switched off, thereby extending battery life. The
rotating laser is still leveled.
1. Press the "Menu" key
2.
Select system setup
3. Use the arrow keys
4. Confirm your selection by pressing the OK key
5.
Activate / deactivate sleep mode by pressing the OK key
NOTE All settings remain saved.
16
2 mm
5 mm
10 mm
25 mm
, select the system settings
to navigate to the correct quadrant.
to return to the "System setup" menu item
on the PRA 300.
.
to navigate to the option "Sleep mode"
and confirm your selection by pressing the
and confirm your selection by pressing the
.
.
.
.
.
¹⁄₈"
¹⁄₄"
¹⁄₂"
1"
and "Sleep mode" . These functions
key.
or press the "Menu" key
key.
to return to