Sage the Barista Touch Impress BES881 Handbuch Seite 9

Assembly
BEFORE FIRST USE
Machine Preparation
Remove and discard all labels and packaging
materials attached to your espresso machine.
Ensure you have removed all parts and
accessories from the box before discarding
the packaging.
Remove the water tank located at the back of
the machine by pulling the water tank handle.
Clean parts and accessories (water tank,
portafilter, filter baskets, jug) using warm water
and a gentle dish washing liquid. Rinse well
then dry thoroughly.
NOTE
Machines with colour, drip tray protection guard
is included. DO NOT DISCARD.
INSTALLING THE WATER FILTER
• Remove the water filter and water filter holder
from the plastic bag.
• Soak the filter in cold water for 5 minutes.
• Rinse the filter holder with cold water.
• Set the reminder for next month of replacement.
We recommend to replace the filter after 3
months.
• Insert the filter into the two parts of the filter
holder.
• To install the assembled filter holder into the
water tank, align the base of the filter holder with
the adapter inside the water tank. Push down
to lock into place.
NOTE
Replacing the water filter every three months will
reduce the need to descale the machine. Filters
can be purchased at www.sageappliances.com
NOTE
If your water hardness is either 4 or 5 when
tested, we strongly recommend you to change
to an alternate water source. Filtered water will
extend both the life of your built-in filter and
descale intervals as well as superior taste.
Please ensure to test the water hardness of
the alternative water source you've chosen and
input into the machine accordingly. Avoid using
overly filtered water, like RO water unless some
mineral content is being added back to the final
water. Never use distilled water, or water with no
or low mineral content as this will affect the taste
of coffee.
EN
9