Sage the Barista Touch Impress BES881 Handbuch Seite 22

CLEANING THE OUTER HOUSING
AND CUP WARMING TRAY
• The outer housing and cup warming tray can be
cleaned with a soft, damp cloth. Polish with a soft,
dry cloth. Do not use abrasive cleansers, pads
or cloths which can scratch the surface.
STORING YOUR MACHINE
• Before storing, press the POWER button to
OFF, switch off at the power outlet and unplug.
Remove unused beans from the hopper, clean
the grinder, empty the water tank and the drip
tray.
• Ensure the machine is cool, clean and dry. Insert
all accessories into position or into the storage
tray. Store upright. Do not place anything on top.
WARNING
To prevent damage, do not use alkaline cleaning
agents when cleaning. Use a soft cloth and
a mild detergent.
WARNING
Do not immerse power cord, power plug or
appliance in water or any other liquid. The water
tank should never be removed or completely
emptied during decalcifying.
CLEANING THE SHOWER SCREEN
Over time, the silicone seal surrounding the
shower screen will need to be replaced to
ensure optimum brewing performance.
1. Press the POWER button to switch the
machine off and unplug the cord from the
power outlet.
2. Carefully remove the water tank and drip tray,
taking particular care if they are full.
3. Using a skewer or similar, clean the centre
of the screw of any residual coffee.
4. Use a flat screw driver (not provided) to
unscrew. Turn counterclockwise to loosen
the screw.
22
Clean centre of screw before
removing the screw using a flat
screw driver (not provided).
5. Once loosened, carefully remove and retain the
screw and stainless-steel shower screen. Make
note of the side of the shower screen that is
facing downwards. This will make re-assembly
easier. Wash the shower screen in warm soapy
water, then dry thoroughly.
6. Remove the silicone seal with your fingers or
a pair of long-nose pliers. Insert the new seal,
flat side first, so the ribbed side is facing you.
7. Re-insert the dispersion plate, then the shower
screen, then the screw. With your fingers, turn
the screw clockwise for 2-3 revolutions and
use a flat screw driver to tighten until the screw
is flush with the shower screen.
8. Re-insert the drip tray and water tank.
NOTE
Contact Sage Customer Service or visit
www.sageappliances.com for replacement
silicone seals or for advice.