Service And Cleaning; Maintenance Work; Dry Vehicle And Equipment; Testing And Inspection Work - Rosenbauer Rte Ax B16 Betriebsanleitung

Service and cleaning

Maintenance work

21 Service and cleaning
21.1 Maintenance work
21.1.1

Dry vehicle and equipment

21.2 Testing and inspection work

86 / 97
NOTICE
Damage to the components through cleaning with high pressure
cleaner!
Pressurised water from high pressure cleaners can damage components
on the product.
Do not use high-pressure cleaners to clean the product!

Maintenance work involves tasks that can be performed by properly trained
fire department personnel.
This work must be carried out regularly, especially after each use, to ensure
optimum condition of the product.
► Keep the safety and warning signs clean and legible.
► Replace missing or damaged signs.
Load only dried equipment into the vehicle, to conserve the service life of
the equipment and the vehicle.
► Let the equipment and device dry before loading.
► Open compartments of the vehicle in the vehicle garage.
WARNING!
Danger of injury and accidents!
Damage to the holding and storage systems, and not properly repaired
equipment can cause injury or danger to a successful operation.
Potential damage must be removed necessarily, before the equipment

is used.
Assessment and inspection work must only be carried out by correspond-
ingly trained personnel, who are familiar with the product.
The work must be carried out regularly, especially after each use, to ensure
optimum operational safety of the product.
All components, locks and fittings of holding and storage systems have to
be checked if they are in a good condition and verify safe storage. Any de-
viation, damage or defects must be corrected immediately or repaired.