Werbung
Verfügbare Sprachen
Verfügbare Sprachen
E13
Before riding the electric kickscooter for the first time, the battery must be fully charged.
Follow the instructions on this user manual to avoid technical problems.
Try to recharge after each ride, which can greatly extend the service life of the battery.
First put the electric kickscooter on a flat surface.
The electric kickscooter is developed for flat grounds. Take care of uneven and bumpy grounds.
Press the power button on the display, to turn-on the display and the unit.
Verify the level of the battery power on the display.
Select the desired gear.
Turn on the lights when driving at night or dark places. Wear a reflective vest, if required by the local laws.
Put one foot on the pedal. Stand on the pedal with one leg only. Keep the two hands on the handlebar.
This e-scooter has a "kick-and-go" function for your safety: this will avoid a standing start.
Just push with the foot your e-scooter forward and the motor will be activated when you reach 3km/h.
Gently press the lever on the right handle: the device will accelerate.
Step on with the other foot whilst the electric kickscooter is moving.
Start-switch failure.
Instructions for use
exists in the connection between controller and
main cable or in the connection between main
cable and speedometer. Measure with the
buzzer of the multimeter at the farthest end of
the corresponding cable connection. If there is
open circuit, you shall check which parts has
breaking circuit and replace that part.
This error is not valid for the current model.
16
Werbung
